Figure 3-19. - Control cubicle, controls, and indicators.
CAUTION Do not crank the engine in excess of 15 seconds at a time. Allow the starter to cool a minimum of 3 minutes between cranking.
WARNING Operation of this equipment presents a noise hazard to personnel in the area. The noise level exceeds the allowable limits for unprotected personnel. Wear earmuffs or earplugs.
12. Set and hold the START-STOP-RUN switch to the START position until the engine starts. As the engine starts, observe the following:
a. The OIL PRESSURE gauge indicates at least 25 psig.
b. The VOLTS AC meter indicates the presence of voltage.
c. The LOW OIL PRESSURE indicator light on the FAULT INDICATOR PANEL goes out.
13. Release the START-STOP-RUN switch. Position the switch to RUN.Continue Reading