Textbook Assignment: Blueprint Reading and Technical Drawings. Pages 4-1 through 4-13. Planning Plumbing
Projects. Pages 7-1 through 7-18.
1-1. What factor is generally used to categorize a
During what phase of a building project is the
preliminary drawing prepared?
What category of drawing is used to make
Shop and working drawings are developed at
which of the following times?
Before developing secondary drawings
After receiving the engineering drawings
Before developing the preliminary
4. After receiving approval for construction
Construction plans are developed from what
type of drawing?
Which of the following individuals designs the
power and lighting system requirements for a
As a supervisor, you should refer to what
documents as the chief source(s) of
information during a construction project?
Bill of materials
Each of the above
Construction prints are used to express ideas
easier and faster. They are also used by the
supervisor for which of the following reasons?
To evaluate personnel
2. To monitor construction progress
3. To determine the necessary construction
4. To determine the electrical load of the
The waterline stub outs, located on the right
side of figure 4-1C, are supplying what fixture?
2. Water closet
1-10. What type of line is used to show the center of
a line or fitting?