4. Place the meter probes across a load. If there is no-voltage reading, you have an inoperative load. Replace the load.

Place one meter probe on the right side of the LLP switch and the other probe on the left side of the IT. If there is no voltage reading, replace the load.

Continuity Readings

To perform an ohmmeter continuity test, set your multimeter to resistance; disconnect the power and remove the wires from the component being tested. Perform a continuity test as follows:

1. Place the meter probes across a path. If a reading is obtained, it indicates an open path.

Place one meter probe on the left side of the CR contact and the other probe on the left side of the HP switch. If you obtain a reading, the path is open.

2. Place the meter probes across a path. If a zero reading is obtained, the path is closed.

Place one meter probe on the left side of the CR contact and the other probe on the left side of the HP switch. With the CR contact closed, you should obtain a zero reading. This indicates the path is closed.