TM 9-243USING A FLARING TOOL - Continued3Hold tubing so there is about 1/8 inch extendingabove die block clamp, and tighten die block clampscrews.NOTEDo not over-tighten cutter as tubing maykink and flatten.4Slide yoke (4) over die block clamp, and align thetip (5) over the end of tubing.5Tighten feed screw (6) forcing the tip (5) into thetubing and forcing the tubing into the chamber of thedie block clamp.6When desired flare is reached, unscrew feed screw,and remove yoke from die block clamp.3 6 - 3
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business