TM 9-243CARE OF BOLT AND CABLE CUTTERS1.Replace worn cutters when necessary.5.Do not sharpen edges too sharp. Leave edge2. Keep moving parts well oiled.approximately 1/64-inch wide for longer jaw life.3.Keep the adjusting screws just tight enough to6.Before storing, wipe dirt and grease from the cutterensure that the cutting edges meet along their entireand coat the metal parts lightly with oil to preventlength when the jaws are closed.rust.4.Keep cutter jaws at right angles to the piece being7.Store the cutter in a special compartment of the toolcut. Do not twist or pry with the tool while cutting.box or on a shelf where it cannot fall.32-5/(32-6 blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business