TM 9-243
USING A TUBING BENDER
1
Raise slide bar (1) and insert tubing (2) to be bent.
2
Raise locking clip (3) and lock tubing in place.
3
Lower slide bar. The zero mark (4) on the slide bar
should match up with the zero mark on the block (5).
5
Stop bending the tubing when the zero mark on the
slide bar matches the desired angle (6) on the block.
6
Raise the slide bar (1), lift up the locking clip (3) and
remove the bent tube (2).
4
Apply downward pressure on the slide bar.
49-3
