3 - 4 3 .   Which   of   the   following   types   of wrenches   is   used   to   tighten   nuts and   bolts   requiring   200   or   more foot   pounds   of   torque? 1.  A  spanner  wrench 2.   A   plug   wrench 3.  A  box  wrench 4.   A   power   torque   wrench 3-44. What   are   the   two   basic   types   of spanner   wrenches? 1.   The   hook-type   and   the   pin-type 2.   The   round-face   type   and   the square-face   type 3.   The   adjustable-type   and   the fixed-type 4.   The   flexible-type   and   the rigid-type 3-45. The   straps   on   strap   pipe   wrenches are   usually   made   from   which   of   the following   materials? 1.   Rubber 2.   Canvas 3.   Leather 4.   Both   2   and   3   above 3-46. Which   of   the   following   wrenches   has one   fixed   jaw   and   one   adjustable jaw? 1.   An   adjustable   open-end   wrench 2.   A   multiple   plug   wrench 3.   A   combination   wrench 4.  A  box  wrench 3-47. A   wedge-type   stud   removers   is normally   made   of   a   socket   housing and  a  total  of  how  many  wedges 1.   Five 2.   Two 3.   Three 4.   Four 3-48. Socket    wrench    extensions    usually range  from  2  inches  to  what  maximum length? 3-49. Which   of   the   following   tools   is   a precision   instrument? 1.   A   strap   wrench 2.   A   torque   wrench 3.   A   bolt   cutter 4.   A   box   wrench 3-50. An  S-shaped  open  end  wrench  is normally   offset   what   number   of degrees? 1. 22    1/2   degrees 2. 15    1/4   degrees 3. 12   2/3   degrees 4. 10   3/4   degrees 3-51. Which   of   the   following   tools   should you   use   to   cut   holes   in   flat   stock and   to   cut   V-groves? 1.   A   center   punch 2.   A   staybolt   tap 3.   A   diamond   point   chisel 4.   A   thread   cutting   tool 3-52. Which   of   the   following   types   of chisels   has   a   beveled   point   on   one edge,   a   flat   face   on   the   other   end, is   10-1/2   inches   long,   and   weighs 5-1/2  pounds? 1.   A   rivet   buster   chisel 2.   A   machinist's   chisel 3.   A   track   chisel 4.   A   woodworker's   chisel 3-53. In   reference   to   a   woodworker's chisel,   which   of   the   following statements   is   true? 1.  Rough  cuts  should  be  made  with the   bevel   side   up 2.   Smooth   finishing   cuts   should   be made  with  the  bevel  side  down 3.  Cuts  should  always  be  made  away from   the   person   doing   the cutting 4.   Both   hands   of   the   person   doing the   cutting   should   be   in   front of   the   cutting   edge   at   all times 1. 10   inches 2. 13   inches 3. 17   inches 4. 36   inches 17