TM 9-243USING A PIPE VISEWARNINGPIPE ENDS ARE EXTREMELY SHARP.HANDLE WITH CARE.NOTEThe following procedure provides thesteps required to fasten a piece of pipe ina hinged jaw pipe vise.1Open the pipe-holding jaws (1) by turning thethreaded T-handle (2)Lift locking device (3) and open pipe vise.3Insert section of pipe (4) in vise and close pipe vise,by pushing locking device against lip on the side ofthe lower holding jaw (5).4Insert locking bolt through aligned holes of upperand lower lip jaws.CAUTIONDo not apply too much pressure to copperor aluminum pipe.5Tighten the pipe holding jaws by turning thethreaded T-handle.CARE OF VISESClean with a rag after each use, and apply a light coatNever oil the swivel base or swivel joint, as thisof oil.decreases its holding power.Never strike avise with a heavy object or try to hold largeWhen not using a vise, bring the jaws lightly togetherwork in a small vise.and leave the handle in a vertical position. This willKeep jaws in good condition.protect the jaws.18-5/(18-6 blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business