Figure 9-13.-Side and top flashing for the doors.Figure 9-14.-Top and bottom hardboard flashing.Figure 9-15.-Metal ventilator flashing.Figure 9-16.-Interior trim.Figure 9-17.-Batten strip.quarter-round molding to trim the ceiling to the endwall, end wall to sidewall, and walls to floor. Usemetal ridge flashing, as shown in figure 9-16, to trimthe ridge of the ceiling liner. It can be attached to theceiling furrings with 4d aluminum nails. Check thedrawings to make sure you are installing it correctly.Next, cut battens to the required length and attachthem to the furring with 4d aluminum nails, 8 inchesOC. An example of this is shown in figure 9-17.9-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business